+91-22-2300 5205/06, +91-22-2309 7759 anushree@surfaceinnovators.comORanishsurfaceinnovators.com

K-2 PICKLING SPRAY (SEMI-GEL FORM)

K-2 Spray is used to clean large fabricated equipment of Stainless steel e.g. Vessels equipment, internals & external of pipes by a pressurized spray bottle or pump.

AREA COVERED

K-2 Spray form covers 40-50 sq.ft. of an area with 1kg. of the chemical.

APPLICATION PROCEDURE FOR K-2 SPRAY

  • Add 50gms of SI. 56 Degreaser to 1 ltr. Of water (5% w/v.). Apply solution on the surface for 10-15minutes & then wash thoroughly and allow the surface to dry.
  • K-2 Spray is to be sprayed on the S.S. Surface with a pressurized plastic spray bottle or spray pump.
  • After spraying leave it for 30-60 minutes then scrub the surface with a plastic bristled brush.
  • Then wash the surface thoroughly with high-pressure water and allow the surface to dry.
  • Next, apply K-2 Passivation solution and leave it for 20-25minutes.
  • Finally rinse the surface thoroughly with demineralized water and dry.

Note:

Chloride content in rinse water should be less than 50ppm.

Shake the products well before use.

Do not apply the products under direct sunlight.

K-2 Passivation is a must after every pickling process.